Table Of Contents

DAQmx Adjust SC Express Calibration (4353) (G Dataflow)

    Last Modified: February 6, 2017

    Adjusts the external calibration constants for an NI PXIe-4353 device.


    calHandle in

    calHandle in is a reference to the calibration session that you created using the DAQmx Initialize External Calibration node.


    physical channels

    physical channels specifies the physical channel(s) to calibrate.


    reference value

    reference value specifies the reference value collected when verifying the calibration. For ai0:1, this value is the reference voltage connected across AI0+/AI0- or AI1+/AI1-, measured using a DMM. For _cjtemp0, this value is the reference resistor connected across CJC0+/CJC0-, measured using a DMM.


    error in

    error in describes error conditions that occur before this node runs. This input provides standard 'error in' functionality.


    calHandle out

    calHandle out is a reference to the calibration session. Wire this output to other external calibration nodes.


    error out

    error out contains error information. If error in indicates that an error occurred before this node ran, error out contains the same error information. Otherwise, error out describes the error status that this node produces.

    Where This Node Can Run:

    Desktop OS: Windows

    FPGA: LabVIEW NXG does not support FPGA devices

    Recently Viewed Topics