Updates a specified ATR register state for advanced LO Low Pass Filter configuration.
is the channel to operate on. Valid options are rx/RF 0, rx/RF 1, tx/RF 0, and tx/RF 1. Use this parameter to determine which daughterboard to update the ATR register state of.
The specific ATR register to write to. The registers correspond to the four states each daughterboard supports. The daughterboard state is set based on whether Rx and Tx are enabled or disabled, using the Enable Front End node. It is safe to call the Enable Front End node after writing to the ATR registers.
The LO LPF state of the daughterboard.
Error conditions that occur before this node runs. The node responds to this input according to standard error behavior.
Default: No error
Error information. The node produces this output according to standard error behavior.
Object created by the Open node and used as the session handle for the USRP RIO nodes.
The niUsrpRio session used in all subsequent USRP RIO host nodes.
Where This Node Can Run:
Desktop OS: Windows
FPGA: Not supported