Table Of Contents

MT Generate CPM System Parameters (map) (G Dataflow)

Last Modified: January 9, 2017

Calculates parameters for use with either MT Modulate CPM or MT Demodulate CPM. Wire the CPM system parameters passed from this node to the corresponding cluster of MT Modulate CPM, MT Demodulate CPM, and MT Detect CPM. It accepts an input array of symbol values that explicitly define the positions of the symbol map.

connector_pane_image
datatype_icon

samples per symbol

Number of samples dedicated to each symbol. Multiply this value by the symbol rate to determine the sample rate.

Default: 16

datatype_icon

symbol indices

Array of symbol values with an order that corresponds to the symbol map. The number of CPM levels specified here must be 2 N , where N is the number of bits per symbol.

datatype_icon

modulation index, h(i)

Modulation index for the CPM modulation scheme.

Refer to CPM Modulation for more information about modulation indices. The modulation index must be of proper form, that is, the numerator must be lesser than the denominator. The modulation index may vary between symbol intervals.

datatype_icon

numerator

Numerator of the modulation index.

datatype_icon

denominator

Denominator of the modulation index.

datatype_icon

symbol rate

The desired symbol rate, in hertz (Hz).

Default: 1.0

datatype_icon

error in

Error conditions that occur before this node runs. The node responds to this input according to standard error behavior.

Default: no error

datatype_icon

CPM system parameters

Parameter values defining the CPM system. Wire this parameter to the corresponding system parameters cluster of MT Modulate CPM, MT Demodulate CPM, or MT Detect CPM.

datatype_icon

samples per symbol

Number of samples dedicated to each symbol. Multiply this value by the symbol rate to determine the sample rate.

datatype_icon

symbol map

A two-dimensional array of desired frequency deviations. Each column corresponds to a symbol, with the binary representation of the column index being the mapped bit-representation of the symbol. Each row corresponds to a modulation index in the order in which it appears in the modulation index, h(i) parameter of MT Generate CPM System Parameters (M) or MT Generate CPM System Parameters (map).

Default: Empty array

datatype_icon

error out

Error information. The node produces this output according to standard error behavior.

Where This Node Can Run:

Desktop OS: Windows

FPGA: Not supported


Recently Viewed Topics