Table Of Contents

ni579x Route Signal (G Dataflow)

Last Modified: January 9, 2017

Routes a signal in the adapter module from the specified source to the specified destination terminal.

connector_pane_image
datatype_icon

Register Bus

Register Bus object created by ni579x Open and used as the session handle for the NI-579x Configuration nodes.

datatype_icon

source

The source signal.

Valid values:

  • None–Disconnects route to destination.
  • LO1–The local oscillator (LO).
  • LO In–The LO IN front panel connector.
  • RX In–The RX IN front panel connector.
  • Tx Mixer Output–The output of the TX mixer.
  • TX I (Mixer Bypass)–The I component of the baseband Tx signal, bypassing the Tx Mixer.
  • Sample Clock–The signal used as the Sample Clock.
  • Reference Clock–The signal used as the Reference Clock for the Sample Clock and the LO.
datatype_icon

destination

The destination terminal.

Valid values:

  • Rx Mixer Input–The modulation signal input to the Rx mixer.
  • Rx Mixer LO Input–The LO signal input to the Rx mixer.
  • Tx Mixer LO Input–The LO signal input to the Tx mixer.
  • Tx Out–The TX OUT front panel connector.
  • LO Out–The LO OUT front panel connector.
  • Clk Out–The CLK OUT front panel connector.
datatype_icon

Error In

Error conditions that occur before this node runs. Use this information to decide whether to bypass any functionality if this node receives errors from other nodes.

datatype_icon

Register Bus (out)

The Register Bus object created by ni579x Open and used as the session handle for the NI-579x Configuration nodes.

datatype_icon

Error Out

Information about errors or warnings that occurred during or before the execution of this node.

Where This Node Can Run:

Desktop OS: Windows

FPGA: Not supported


Recently Viewed Topics