Academic Company Events Community Support Solutions Products & Services Contact NI MyNI

Legacy: Setting GPIB Properties in Windows NT

Accessing the GPIB Configuration Utility

  • Under Start » Settings » Control Panel, select the GPIB icon:

    Control Panel



Setting Board Properties

  1. The GPIB Configuration Utility initially looks like this (assuming you have a GPIB board installed):

    GPIB Configuration Utility


    Notice that GPIB0 is highlighted under the list of GPIB Boards on the left-hand side of the image. If you wish to edit a Device Template, then you must select a device instead, such as DEV1 (see below).

      Remember: The term device refers to instruments, while the term interface refers to GPIB boards.


  2. Click on the Configure button to open the Configure window:

    Configure Window

      Note: The Analyzer Resources button will only be present, if you
      have a GPIB "plus" board with the special analyzer hardware on it.

    This is the type of window you would see for a plug and play GPIB board.


    You can click on the Controller Resources button to view or edit the system resources assigned to your GPIB board. See the GPIB troubleshooting page on Resolving Resource Conflicts in Windows NT for more information on how to adjust your board's resources.


  3. Click on the Software » button to expand the Configure window:

    Expanded Configure Window


    The default property settings for a typical GPIB PnP board are shown in the image above. See the page of Tips on Setting GPIB Properties in Windows NT for assistance.


Setting Device Properties

  1. Select a device name from the list of Device Templates on the right-hand side of the GPIB Configuration Utility window:

    GPIB Configuration Utility


    The Device Templates give you access to device-specific settings, such as an instrument's Device Name, any special Termination Methods, and the name of the GPIB interface (i.e., board) that the instrument is communicating with.

      Remember: The term device refers to instruments, while the term interface or access board refers to GPIB boards.


  2. Click on the Configure button to open the Configure window:

    Device Template


    The default settings for a typical GPIB instrument/device are shown in the image above. See the page of Tips on Setting GPIB Properties in Windows NT for assistance.


Your Feedback! poor Poor  |  Excellent excellent   Yes No
 Document Quality?   Answered Your Question? 
  1 2 3 4 5
Please Provide Additional Feedback below
Please visit Request Support for product support inquiries. submit