Archived: Traditional NI-DAQ (Legacy) Driver Support: Plug and Play ISA/PC/AT
Updated May 26, 2020
NI does not actively maintain this document.
This content provides support for older products and technology, so you may notice outdated links or obsolete information about operating systems or other relevant products.
The following table lists the latest DAQ driver that is supported for various National Instruments Plug and Play ISA/PC/AT data acquisition devices. The table also shows which driver can be used with Windows, Linux, Real-Time or Mac OS X.
Note: This page is about NI-DAQ also known as Traditional NI-DAQ (Legacy). NI-DAQmx replaced Traditional NI-DAQ (Legacy) in 2003. NI strongly recommends using NI-DAQmx for new designs and migrating existing Traditional NI-DAQ (Legacy) applications to NI-DAQmx. Please review the Getting Started with NI-DAQmx guide for more information on migration.
1. PCI, PXI, PCIe and PXIe - Devices listed by NI [Family Number] are available in both PCI and PXI Bus architectures. Devices listed with NI PXI- or NI PCI- before the number are available in that specific Bus architecture only. For Example, the Counter/Timers listing for the NI PCI-6601, NI 6602, NI 6608 indicates the NI 6601 is only available for the PCI Bus but the NI 6602 and NI 6608 are available for both the PCI and PXI Bus architectures. PXIe and PCIe devices are always listed separately.
2. NI-DAQ 6.9.3 or Earlier requires NT Service Pack 4 or greater. NI-DAQ 7.x (Traditional and mx) requires NT Service Pack 6 or greater.
3. For information on supported Linux distributions, visit /linux/support.htm#1 or see the driver readme file.
4. The host system must also support the version of NI-DAQ listed. NI-DAQmx for LabVIEW RT is only supported on Pharlap RT Systems with LabVIEW RT installed.