Filtered Results

In your Logging specification document, specify values for the Operator and DUT in the Test Properties section, if desired. The fields for Operator and DUT are auto-populated, but can be changed or deleted, ...

Before adding CAN and LIN signals to your Channel Specification, you may need to create or manage the databases that provide the signal definitions and scaling information for your application. Refer to ...

CAN interfaces are software representations of physical ports. Complete the following steps to adjust the port settings. Enable Termination, if necessary. Improperly configured Termination schemes might ...

Click Add Signals on the CAN port you want to configure. Select the Database that contains the signals you want to update. Select the Cluster that contains the signals you want to apply J1939 to. Select ...

Although it is possible (and supported) in principle to run a network without a database, using a database is highly recommended to have a consistent set of network parameters for all nodes in the network. ...

Hover over the channel row to see the Configure gear . Click the gear for the channel you wish to configure. The channel configuration dialog opens. Use the Name field to specify the channel name, if necessary. ...

Add a calculated Boolean channel to produce a high or low Boolean digital signal based on an analog channel. In the Channel Specification, click the Add Calculation button and select Boolean Formula from ...

Hover over the channel row to see the Configure gear . Click the gear for the channel you wish to configure. The channel configuration dialog opens. Use the Name field to specify the channel name, if necessary. ...

Refer to the following information to configure your device channels. Configuring I/O Channels Configuring an Automotive Bus Configuring Calculated Channels After you configure your channels, you can start ...

Showing 1-10 of 66 results
1 of 7 pages