Complete the following steps to connect the cRIO-9039 to the host computer using the USB device port. Power on the host computer. Connect the cRIO-9039 to the host computer using the USB A-to-B cable. ...

Ensure that the USB connections between the cRIO-9039 and the host computer and the Ethernet connections between the host computer and the router are secure. Configure the IP and other network settings ...

This product was tested and complies with the regulatory requirements and limits for electromagnetic compatibility (EMC) stated in the product specifications. These requirements and limits provide reasonable ...

Complete the following steps to install software on the cRIO-9039 . In MAX, expand your system under Remote Systems. Right-click Software . Select Add/Remove Software to launch the LabVIEW Real-Time Software ...

Before using the cRIO-9039 , you must install the following application software and device drivers on the host computer in this order: Sequence cRIO-9039 cRIO-9039 Sync 1 LabVIEW 2014 SP1 or later LabVIEW ...

When you power on the cRIO-9039 for the first time, the device boots into safe mode. The POWER LED illuminates, the STATUS LED illuminates briefly, and then the STATUS LED blinks twice every few seconds. ...

Ensure that the environment in which you are using the cRIO-9039 meets the following specifications. Operating temperature (IEC 60068-2-1, IEC 60068-2-2) -20 °C to 55 °C Operating humidity (IEC 60068-2-78) ...

Verify that power is not connected to the I/O connector(s) on the C Series module before you remove a module from the cRIO-9039 . If the system is in a nonhazardous location, the cRIO-9039 can be powered ...

Caution Observe all instructions and cautions in the user documentation. Using the model in a manner not specified can damage the model and compromise the built-in safety protection. Return damaged models ...

Complete the following steps to set a system password. Note The default username for the cRIO-9039 is admin . There is no default password for the cRIO-9039 , so you must leave the password field blank ...

The following table describes the STATUS LED indicators. Table 3. STATUS LED Indicators LED Color LED Pattern Indication Yellow Blinks twice and pauses The cRIO-9039 is in safe mode. Software is not installed, ...

Software is licensed pursuant to the software license agreements provided with the software or, in the absence of such license agreements, the National Instruments Software License Agreement available ...

The following figure shows the reset behavior of the cRIO-9039 . Figure 3. Reset Button Behavior Press and hold RESET button fo r ≥ 5 s Press and hold RESET button for < 5 s Run Mode Safe Mode Press

Notice To prevent electrostatic discharge (ESD) from damaging the device, ground yourself using a grounding strap or by holding a grounded object, such as your computer chassis. Touch the antistatic package ...

Put the cRIO-9039 in safe mode and enable the RS-232 serial port by holding the RESET button down for 5 seconds. The STATUS LED starts blinking three times every few seconds. Use the RS-232 serial port ...

Verify that the following items are included in the cRIO-9039 kit. Parent topic: Overview Parent topic: GSG Purpose (cRIO/sbRIO)

This document lists the specifications for the NI cRIO-9039 and NI cRIO-9039 Sync . The following specifications are typical for the -20 °C to 55 °C operating temperature range unless otherwise noted. ...

Definitions Warranted specifications describe the performance of a model under stated operating conditions and are covered by the model warranty. Characteristics describe values that are relevant to the ...

Definitions Warranted specifications describe the performance of a model under stated operating conditions and are covered by the model warranty. Characteristics describe values that are relevant to the ...

Showing 181-200 of 282147 results
10 of 14108 pages