Filtered Results

You can configure the analog gain on both the receiver (RX) and transmitter (TX) signal paths with the NI-mmWave Configuration API.

The PXIe-3610 Waveform Generatorrevision B module and the PXIe-3630 Digitizerrevision B module support transmitter (TX) to receiver (RX) improved (deterministic) data alignment.

The mmWave Transceiver System supports fast configuration of gain and mmWave port switches.

You can set a rough gain very quickly and adjust to an exact gain slightly later by using fine gain ranging and coarse gain ranging together.

You can configure the mmRH-3602/3603 to route mmWave signals to and/or from one of the following two mmRH-3602/3603 radio head antenna ports: TX1/RX1 and RX2.

To determine which module revision you have of the PXIe-3610 Waveform Generator or PXIe-3630 Digitizer , complete one of the following tasks: Refer to the label on the side of your module; the part number ...

You can configure the PXIe-3620 RF Upconverter and Downconverter Module module to use an external local oscillator (LO) signal when preparing the signal for upconversion or downconversion.

This manual contains information about using NI-mmWave 19.0 to 20.0 to program your mmWave Transceiver System with LabVIEW 2018, 2019, and 2020.

scope Input Most VIs in the NI-mmWave Configuration API require a scope input string. This string specifies the scope of the configuration for the VI. Each VI has a unique set of valid values for this ...

Synchronization occurs between all baseband transmitters and baseband receivers in your system so that generation and acquisition can begin on the FPGA during the same cycle.

The NI mmWave Reference Project contains an example VI that demonstrates how to use the mmWave Transceiver System as a multichannel transceiver.

Home Support Documentation Release Notes NI-mmWave NI-mmWave Release Notes This page provides information related to a specific NI-mmWave version release including release notes, known issues, bug fixes, ...

This page shows operating system compatibility for NI hardware. Reference this information to ensure your selected hardware and driver combination is supported on your desired operating system.

This page shows operating system compatibility for NI hardware. Reference this information to ensure your selected hardware and driver combination is supported on your desired operating system.

NI-mmWave 19.0 Readme May 2019 This file contains important information about NI-mmWave , including installation instructions, new features, a partial list of bugs fixed for NI-mmWave 19.0, and known issues ...

NI-mmWave 15.3 Readme June 2017 This file contains important information about NI-mmWave , including installation instructions, new features, and a partial list of bugs fixed for NI-mmWave 15.3, and known ...

NI-mmWave 18.0 Readme September 2018 This file contains important information about NI-mmWave , including installation instructions, new features, a partial list of bugs fixed for NI-mmWave 18.0, and known ...

NI-mmWave 18.1 Readme October 2018 This file contains important information about NI-mmWave , including installation instructions, new features, a partial list of bugs fixed for NI-mmWave 18.0, and known ...

NI mmWave 15.1 Readme September 2016 Thank you for using NI mmWave. This file contains important information about NI mmWave and is organized into the following sections: New Features Supported Hardware ...

Showing 1-20 of 25 results
1 of 2 pages