The update fixes the three issues below and is strongly recommended for all NI-Serial installations. It also adds support for Windows 8 and the NI System Configuration API.
Issues Fixed in the NI-Serial 3.9 Update
NI-Serial 3.9 fixes an issue in LabVIEW Real-Time where various errors could be manifested if a serial transfer is in progress when the 32-bit system tick count rolls over, which happens once every 49.7 days. Symptoms included failed serial transfers, FIFO overruns, failure of serial transfers to timeout, and system hangs.
NI-Serial 3.9 resolves an issue where a system could crash after removing PCI-based hardware from a hibernated system. Depending on the system configuration, the crash could occur immediately upon resume, or at a later time.
NI-Serial 3.9 resolves an issue which limited the usable baud rate from the .NET SerialPort interface to 131072 baud. This error occurred because NI-Serial improperly reported the maximum baud rate as BAUD_128K (The maximum constant supported by the API) when the port actually supported higher baud rates. This has been changed to report BAUD_USER, indicating that custom baud rates are supported. Other applications querying the maximum baud rate may have been impacted as well.
The update is available via Update Service, or from the Drivers and Updates links below.
You probably noticed we have a new look, but our focus remains on you. We've expanded our offerings to better serve you so that you can take on the complex challenges facing humanity today, tomorrow, and for the next 100 years. It's time. Let's Engineer Ambitiously.