Sound and Vibration Toolkit 2018 Bug Fixes


This document contains the Sound & Vibration Toolkit 2018 bug fixes that were correct before the release of Sound & Vibration Toolkit 2018. Not every issue corrected by NI will appear on this list; it is intended to only show the severe and common issues.

Bug Fixes

The following items are Bug Fixes in Sound and Vibration Toolkit 2018.

ID Description
663480 "Incorrect requirements Documentation for ""Log Data(Digital Tach, DAQmx).vi"" LabVIEW Example"
681819 Measure Delay Equal Polarity fails when cross correlation mean is negative
682046 Discrete Frequency Sweep example results do not reach stop frequency
684548 Dynamic Signal Generator trigger status is incorrect

Glossary of Terms


  • Bug ID - When an issue is reported to NI, you may be given this ID or find it on  You may also find IDs posted by NI on the discussion forums or in KnowledgeBase articles.
  • Legacy ID – An older issue ID that refers to the same issue.  You may instead find this issue ID in older known issues documents.
  • Description - A few sentences which describe the problem. The brief description given does not necessarily describe the problem in full detail.
  • Workaround - Possible ways to work around the problem.
  • Reported Version - The earliest version in which the issue was reported.
  • Resolved Version - Version in which the issue was resolved or was no longer applicable. "N/A" indicates that the issue has not been resolved.
  • Date Added - The date the issue was added to the document (not the reported date).