From Friday, April 19th (11:00 PM CDT) through Saturday, April 20th (2:00 PM CDT), 2024, ni.com will undergo system upgrades that may result in temporary service interruption.
We appreciate your patience as we improve our online experience.
Archived: 在DAQ小幫手中修改實體通道時發生錯誤訊息"Bad Edge Will Not Be Added to Wire (...)"
This document has been archived and is no longer updated by National Instruments主要軟體:
主要軟體版本: 7.1
主要軟體修正版本: N/A
次要軟體: Driver Software>>NI-DAQmx
|
||||||||||||||||||||||||||||||||||||||||||||||||||
問題:
我使用NI-DAQmx 8.0及LabVIEW 7.1,當我在DAQ小幫手中修改實體通道時,出現錯誤訊息"Bad edge will not be added to wire (...)",如下圖所示:
解答:
在DAQ小幫手中修改實體通道前,要先清除連接Express VI的相關接線,所以在改變實體通道前,你需要移除接線才行
相關連結:
附加檔案:
- WireError.GIF
|
||||||||||||||||||||||||||||||||||||||||||||||||||
報告日期: 04/27/2006
最後更新: 10/21/2015
文件偏號: 3WQHETX6