Refer to the following figure for information about other product tasks and associated resources for those tasks. EXPLORE LEARN CREATE DISCOVER Located online at n i . c o m / manuals the application development ...

In addition to the required items, you may choose to provide one or more of the following ATCA I/O modules.

In addition to the kit contents, you must provide the following additional items: Single-Module ATCA Chassis [1] Note If your kit does not include a chassis, you can purchase one from ni.com or by contacting ...

This document describes how to install, configure, and test the ATCA-3671 FPGA Module for ATCA. The ATCA-3671 is programmable both through LabVIEW using LabVIEW FPGA and through BEEcube Platform Studio ...

Ensure that the environment you are using the ATCA-3671 in meets the following specifications.

Disconnect all cables from the ATCA-3671 module. Loosen the four captive screws on the front panel of the ATCA-3671 module. Push up on the latch and rotate the ejector handle away from the module to unseat ...

Disconnect all cables from the RTM. Loosen the four captive screws on the back panel of the RTM. Use the ejector handles to unseat the RTM from the chassis. Carefully remove the RTM from the chassis. Use ...

Figure 14. RTM-3661 Front Panel D D C C B B A A PCIe D PCIe D PCIe C PCIe C PCIe B PCIe B PCIe A PCIe A RTM-3661 Rear Transition Module for ATCA Designed by BEEcube Designed by

The NI website is your complete resource for technical support. At ni.com/support , you have access to everything from troubleshooting and application development self-help resources to email and phone ...

If an issue persists after you complete a troubleshooting procedure, contact NI technical support or visit ni.com/support.

Notice To prevent electrostatic discharge (ESD) from damaging the device, ground yourself using a grounding strap or by holding a grounded object, such as your computer chassis. Touch the antistatic package ...

ATCA-3671 module Ethernet cable ATCA-3671 Getting Started Guide (this document) Note Your ATCA-3671 kit may contain additional NI ATCA products. Parent topic: Unpacking the Kit

This error is caused by a TCP timeout during attempts to communicate with the ATCA-3671 over Ethernet.

You will receive this error if you complete the two steps to deploy a bitfile to the ATCA in the incorrect order.

Definitions Warranted specifications describe the performance of a model under stated operating conditions and are covered by the model warranty. Characteristics describe values that are relevant to the ...

The NI Automated Measurements Board for NI ELVIS III supports teaching the fundamentals of measurements and instrumentation for common electrical and physical phenomenon. You can explore the full signal ...

Definitions Warranted specifications describe the performance of a model under stated operating conditions and are covered by the model warranty. The following characteristic specifications describe values ...

Gather the following information about your application needs and understand the impact that each of the following considerations could have before designing your test system based on the Replay and HIL ...

The ATCA-3671 achieves mechanical and electrical compatibility with the ATCA (Advanced Telecommunications Computing Architecture) 3.0 specification, and it is intended for use with an ATCA 3.0-compliant ...

Table 4. ATCA-3671 GPIO Connector Pin Assignments AUX I/O Connector Pin Signal Signal Description 18 16 14 12 1 0 8 6 4 2 19 17 1 3 5 7 9 11 13 15 1 GND Bidirectional single-ended (SE) digital

All modules must be properly installed within the ATCA chassis before you connect to a host computer or PXI chassis. Note Ensure that the ATCA-3671 is powered on and has finished initializing before connecting ...

31-60 de 282147 résultats
2 de 9405 pages