Channel-disconnect switch is used to connect or disconnect the digital input and output to the front I/O connector. Note The channel-disconnect switch is controlled through software and the switching rate ...
The SLSC-12202 has 32 digital input/output channels that allow the direction to be configured for each channel. The 32 channels are organized into two banks of 16 channels each. Each bank can be powered ...
The short-circuit fault and front I/O overvoltage fault share one common fault indicator which is stored in a register. Note Refer to the example LabVIEW VI to get more information about module registers. ...
Digital input and output channels are protected against overvoltage which is outside of the valid operating range at the front I/O connector up to ±100 V . Note Overvoltage protection is based on hiccup-mode ...
SLSC-12202 Digital Input/Output 32 Ch, 5 V to 60 V CONNECTOR J1 (Ports 0 and 1) CONNECTOR J2 (Ports 2 and 3) This document explains how to connect the SLSC-12202 . Note Before you begin, read the SLSC-12202 ...
Overcurrent fault is a scenario when a digital output is sourcing or sinking a continuous output current greater than 150 mA before the short-circuit protection is activated. Caution The number of digital ...
Refer to the product Declaration of Conformity (DoC) for additional regulatory compliance information. To obtain product certifications and the DoC for NI products, visit ni.com/product-certifications ...
Digital output channels are protected against short-circuit faults. Note Short-circuit protection is based on hiccup-mode protection where the control logic will disconnect the channel using the channel-disconnect ...
Visit ni.com/support to find support resources including documentation, downloads, and troubleshooting and application development self-help such as tutorials and examples. Visit ni.com/services to learn ...
Read this document before you install, configure, operate, or maintain this product. Users are required to familiarize themselves with installation and wiring instructions in addition to requirements of ...