NI FlexRIO Adapter and NI FlexRIO FPGA Module Compatibility
Updated May 29, 2020
This page shows which NI FlexRIO Adapter Modules are supported by NI FlexRIO FPGA Modules and Controllers. Reference this information to ensure you install compatible adapter modules with your FlexRIO FPGA device. Using incompatible hardware may result in errors, failure to compile, the inability for your operating system to recognize or detect and then find a driver for your device, or missing devices in NI Measurement & Automation Explorer (MAX).
In the Downloads section at the bottom of this page, you can download a copy of these tables, which may include older versions.
Note that this article replaces KnowledgeBase 6CBED5QE: What Adapter Modules Are Supported on my NI FlexRIO?Some NI manuals may still reference the previous document. If you were redirected from the previous KnowledgeBase URL, please update your bookmarks accordingly.
Use this table to compare the compatibility of NI FlexRIO Camera Link Adapter Module and NI FlexRIO FPGA Modules
FlexRIO Adapter Module
FlexRIO FPGA Module
 The size and speed grade of the NI PXIe-7965 makes it difficult to meet timing for higher performance adapter modules.
 The 579x FAMs use a sample project that is too large to fit on smaller FPGAs
 The AT FAMs require a driver available at Drivers and Updates: AT-1120 / AT-1212
 The NI 1483R FAM requires the IMAQ driver available at Drivers and Updates: NI-IMAQ
The following Flexrio Adapter Modules (FAMs) are compatible with the 7975 in LabVIEW 2013 SP1: 5761, 5771, 5772, 5782, 5791, 5792, 5793. All other FAMs that support the 797x FPGA Modules require LabVIEW: 2014 or later.