SystemLink 20.0 Known Issues

Created May 15, 2020

Aperçu

This document contains the SystemLink 20.0 known issues that were discovered before and since the release of SystemLink 20.0. Known issues are performance issues or technical bugs that NI has acknowledged exist within this version of the product.

 

Not every issue known to NI appears on this list; it is intended to show the most severe and common issues that you may encounter and provide workarounds when possible. Other technical issues that you may encounter could occur through normal product use or system compatibility issues. You may find more information on these issues in NI’s Product Documentation, Knowledgebase, or Community.

Bug Number

Legacy ID

Description

Details
966801

Asset self-calibration status does not update after unlocking a locked system

Attempting to start an asset self-calibration on a locked system will correctly show "System Locked (changes suspended)" under Status. If the system is subsequently unlocked, the status will change to "Self-Calibrating" but will not update further. This issue is cosmetic only, and the self-calibration completes correctly.

Workaround:

Run the self-calibration again with the system unlocked to reset the status.

Reported Version:

SystemLink: 20.0

Resolved Version:

N/A

Added:

Feb 27, 2020
972321

Querying TDM Reader for multiple files by ID may error on large requests

The Web Server logs shows the following error:

Service for routing key [Skyline.TDMReader] did not respond within the timeout of 30000 milliseconds.

Workaround:

Reduce the number of files requested in a single query to avoid a timeout.

Reported Version:

SystemLink: 20.0

Resolved Version:

N/A

Added:

Feb 27, 2020
211182

Using the browser navigation buttons does not correctly change a query

On pages with a query panel (Assets, Calibrated Assets, Reports, etc.), the browser back button does not work as expected. When a user presses the back button, the URL in the browser changes, but the filters do not.

Workaround:

Remove the filter using the X button next to the property selection field instead.

Reported Version:

SystemLink: 19.5

Resolved Version:

N/A

Added:

Feb 27, 2020
959907

Test results group by selection is ignored when a filter is changed

The Test Monitor test results table allows grouping results by property. When a user selects a group by property and adds a filter, the group by behavior is incorrect. Results are shown separately instead of grouped.

Workaround:

Select a different property to group by and then re-select the original property to reset the table.

Reported Version:

SystemLink: 19.6

Resolved Version:

N/A

Added:

Feb 27, 2020

Final Time Issue Listed

Issues found in this section will not be listed in future known issues documents for this product.

 

There are currently no issues to list.

Additional Resources

Explore Support Content and Product Documentation 

 

 

Ask the NI Community

 

 

Request Support from an Engineer

 

A valid service agreement may be required, and support options vary by country

 

Glossary of Terms

 

  • Bug ID - When an issue is reported to NI, you may be given this ID or find it on ni.com.  You may also find IDs posted by NI on the discussion forums or in KnowledgeBase articles.
  • Legacy ID – An older issue ID that refers to the same issue.  You may instead find this issue ID in older known issues documents.
  • Description - A few sentences which describe the problem. The brief description given does not necessarily describe the problem in full detail.
  • Workaround - Possible ways to work around the problem.
  • Reported Version - The earliest version in which the issue was reported.
  • Resolved Version - Version in which the issue was resolved or was no longer applicable. "N/A" indicates that the issue has not been resolved.
  • Date Added - The date the issue was added to the document (not the reported date).