NI CompactRIO and R Series MultifunctionRIO (August 2015) Bug Fixes

Overview

The following items are a subset of issues fixed in NI CompactRIO Device Drivers August 2015 and NI R Series Multifunction RIO Device Drivers August 2015 since NI-RIO Device Drivers February 2015. If you have an issue ID, you can search this list to validate that the issue has been fixed in NI CompactRIO Device Drivers August 2015 or NI R Series Multifunction RIO Device Drivers August 2015with LabVIEW 2015.

 

IDFixed Issue

441205

The NI 9213 in Scan Interface mode reports open thermocouple errors for all channels when a single channel is disconnected.

523452

When using a Dynamic Signal Acquisition Module, like the NI 9229, the LabVIEW FPGA Module does not prevent implicit synchronization.

514671

The NI 9219 in Scan Interface mode may report incorrect temperature below 20° F with a J type thermocouple.

 

Glossary of Terms

 

  • Bug ID - When an issue is reported to NI, you may be given this ID or find it on ni.com.  You may also find IDs posted by NI on the discussion forums or in KnowledgeBase articles.
  • Legacy ID – An older issue ID that refers to the same issue.  You may instead find this issue ID in older known issues documents.
  • Description - A few sentences which describe the problem. The brief description given does not necessarily describe the problem in full detail.
  • Workaround - Possible ways to work around the problem.
  • Reported Version - The earliest version in which the issue was reported.
  • Resolved Version - Version in which the issue was resolved or was no longer applicable. "N/A" indicates that the issue has not been resolved.
  • Date Added - The date the issue was added to the document (not the reported date).