Filtered Results

How can I synchronize timing for my R Series FPGA boards, either inside of my PXI chassis or in a RTSI-connected PCI system?

I have a 2-wire, 3-wire, or 4-wire Resistance Temperature Detector (RTD) that I want to connect to my data acquisition (DAQ) device. What do the different color wires on my RTD mean, and how do I physically ...

I want to control a stepper motor drive (step/direction) using the digital output on my USB DAQ and I have connected all the necessary wiring, so how do I control the motor for some simple moves in LabVIEW? ...

How do I measure current with an analog voltage input? Do I need a shunt resistor in my current measurement circuit?

I have a NI Multifunction I/O module with some Analog Output (AO) lines. I need to control an instrument using current. What is the current range the AO lines on my card?

I am deploying an application that uses a USB DAQ device and everything works fine. However, every time I connect the USB DAQ device, the NI Device Monitor popup window shows up with a Device Detected ...

I found the equation for Absolute Accuracy of measurements on NI's website, but how will I observe this in my data?

This tutorial provides step–by-step instructions for setting up your USB R Series device, adding it to a project, and creating an analog input acquisition using a DMA FIFO. Requirements Software LabVIEW ...

I have two I/O devices of the same type (i.e. two sinking or two sourcing ones). I want to connect them together. Is that possible? Does my sinking output device require an external voltage source?

The PXI(e) card in my chassis will not perform a Self-Calibration in NI MAX. I'm getting the following error message: Status Code: -201295 Device could not complete the calibration operation. Calibration ...

Showing 71-80 of 246 results
8 of 25 pages