Filtered Results

When I set my trigger to be retriggerable and I run my VI I get the following error: Error -200077 occurred at Property Node DAQmx Trigger (arg 1) in DAQmx Start Trigger (Analog Edge).vi:2->Your VI Name.vi ...

I want to know which driver to install so I can work with my SCXI modules. How do I check the compatibilities between the driver versions and the hardware?

I would like to implement an application that collects data from the PXIe-4330 if the analog edge voltage from the PXIe-4492 is greater than 1 V using DAQ Assistant in LabVIEW. However, I couldn't find ...

Error -50200 occurred at DAQmx Create Timing Source VI when implemented on a NI Linux RT cDAQ-9137. Error -50200 occurred at DAQmx Create Timing Source (Control Loop From Task).vi:6770001 Possible reason(s): ...

I want to synchronise my signal acquisition in with DAQmx in LabVIEW, how can I do that and what are my options?

I want to see a NI-DAQmx example project for LabWindows/CVI, but when I open the NI Example Finder and search for NI-DAQmx examples, it only shows the "counter measurements" folder. Where can I find more ...

I am trying to trigger acquisition on NI data acquisition device using the DAQmx Start Trigger.vi, with an analog trigger but I get error 200265. The error also does not indicate any "Valid Choices".

I am using the DAQ Assistant. When going through the configuration I am able to set the Samples to Read and the Rate (HZ). However, after the VI builds onto the block diagram, I am able to set the nodes ...

I ran out of available Analog Input ports on my data acquisition device. However, there are some Digital Input ports available, can I use them as Analog Input ports? How are they going to behave?

The specifications of my NI DAQ device show it has a built in CJC (cold junction compensation) sensor. How do I use this sensor with my temperature readings?

Showing 71-80 of 23598 results
8 of 2360 pages