Filtered Results

Takes binary data from a specified file of 16-bit integers and creates an onboard waveform for use in arbitrary waveform or arbitrary sequence output modes. The waveform generator must not be in the Generating ...

Takes the data provided and creates an onboard waveform of the same size for use in arbitrary waveform or arbitrary sequence output modes.

Sets the FIR filter coefficients used by the onboard signal processing block. The values are coerced to the closest settings achievable by the waveform generator. The waveform generator must not be in ...

Configures the Start Trigger for edge triggering, setting the trigger source and edge to detect. The waveform generator must not be in the Generating state when you call this node. Not supported Not supported ...

Use the NI-FGEN external calibration utility nodes to get information about previous calibrations, store information, or password protect the external calibration data on your board.

Use the NI-FGEN filter nodes to configure analog and digital filtering of your waveform generator.

Use the NI-FGEN flatness control nodes only when following the flatness calibration section of the waveform generator calibration procedure.

Retrieves user-defined information from the onboard EEPROM. Not supported Not supported in VIs that run in a web application niFgen Get Cal User Defined Info.vi :/nifgenlv.chm::/niFgen_Get_Cal_User_Defined_Info.html ...

Reads and returns the current onboard temperature of the waveform generator. Not supported Not supported in VIs that run in a web application niFgen Read Current Temperature.vi :/nifgenlv.chm::/niFgen_Read_Current_Temperature.html ...

Returns the recommended interval between external calibrations in months. Not supported Not supported in VIs that run in a web application niFgen Get Ext Cal Recommended Interval.vi :/nifgenlv.chm::/niFgen_Get_Ext_Cal_Recommended_Interval.html ...

Showing 51-60 of 140 results
6 of 14 pages