Filtered Results

This document is a part of How-To Guide for Most Common Measurements centralized resource portal. RTD Overview A platinum resistance temperature detector (RTD) is a device with a typical resistance of ...

I am acquiring vibration from an IEPE(Integrated Electronics Piezo-Electric)accelerometer with a NI-9234 module, and I am observing the maximum value of saturation for the first 5 seconds of data acquisition: ...

We are using the same hardware on different computers in our project. Every time we connect the device(s) or reinstall a PC, the NI Product Registration Wizard window shows up to register the product(s). ...

This document is part of the Getting Started with NI-DAQmx Series. A Pulse Width Modulation (PWM) Signal is a technique for generating digital pulses to control an analog circuit. A PWM signal consists ...

I can see some incorrect peaks of data when measuring from a volumeflow sensor with DAQmx.Constant signal and volume flow are displayed on the control side of our system. A look with an oscilloscope also ...

I would like to calculate the impedance of a resistor. Can I use a Multifunction DAQ device to calculate the value of an unknown or variable resistance?

I have a DAQ device (cDAQ, USB, or PXI(e)) and I would like to communicate with it using low level VISA SCPI commands. Is this possible and is there a manual with the SCPI commands? Also, do SMU cards ...

I have a CompactDAQ (cDAQ). I want to control my 3 stepper motors. These will be simple, straight line moves. Can I use my cDAQ?

I ran out of available Analog Input ports on my data acquisition device. However, there are some Digital Input ports available, can I use them as Analog Input ports? How are they going to behave?

My NI device is not correctly recognized in NI Measurement & Automation Explorer (NI MAX). I see the following behavior: The module is shown with a red X icon in NI MAX The module Settings window shows ...

Showing 51-60 of 247 results
6 of 25 pages