Filtered Results

I would like to know what is the maximum number when cascading multiple NI SMU.

I am trying to use an SMU to source current or voltage, but I want to simultaneously measure the current and voltage across the load. Is this possible with an SMU? Do I need any additional ammeters or ...

I have a DAQ device (cDAQ, USB, or PXI(e)) and I would like to communicate with it using low level VISA SCPI commands. Is this possible and is there a manual with the SCPI commands? Also, do SMU cards ...

The legacysoft front panel forNI programmable power supplies and SMUshas been deprecated since NI-DCPower 18.1 in favor of InstrumentStudio. InstrumentStudio is a64-bitsoft front panel applicationthat ...

This document will discuss the technical details of testing the output short circuit current of digital semiconductor devices using a test system created with the PXI platform. Output short circuit current ...

Can I have multiple outputs on my PXIe Source Measurement Unit (SMU) running simultaneously in different modes? (i.e. Channel 0 running in Constant Voltage Modeand Channel 1 running in Constant Current ...

I've configured my NI SMU for remote sense, but when I disconnect the remote sense lines I still see a reading and do not see an error. Why do I still see a reading without the lines connected?

This article describes how an SMU device is configured in order to work in a specific quadrant. It also shows examples of how to do that for each of the four quadrants.

There is a significant amount of noise on the constant current output of my SMU. How can I reduce it? I'm sourcing a constant current from my PXI(e) Source Measurement Unit (SMU) card, but the signal is ...

I have created a sequence in DCPower for my Source Measure Unit (SMU) to output and have reduced the source delay time, however, it seems that the steps always advance every ~15 ms. My SMU is specified ...

Showing 51-60 of 238 results
6 of 24 pages