I would like to use a NI XNET 9860 with a cRIO 904X, 905X or sbRIO 960X, 9628, 9629, 9638 in LabVIEW. I created a LabVIEW project and added these as a new target. Then I have been trying to add on my chassis ...

I have a CompactRIO or sbRIO target in my LabVIEW project as a target but want to change the target to another device of the same model. How can I do this?

When deploying code to a Real-Time controller (CompactRIO, PXI, sbRIO, roboRIO, etc.), it fails with an error similar to the following: .vi loaded with errors on the target and was closed. LabVIEW: ...

I am attempting to run an FPGA VI in interactive mode on a RIO device. The VI compiles and downloads successfully, but when it starts I see the following message and dialog box below.How can I resolve ...

I am attempting to install software on my NI real-time target, but it hangs at base.tar and times out. How can I overcome this error?

Receiving error -50101, -50152 or -61018 when trying to communicate with a remote CompactRIO device. This behavior is showing up either when I try to download an FPGA VI, detect C-Series modules in LabVIEW, ...

I get the error"This C Series Module is Not Supported By This Version of LabVIEW and NI-RIO" when trying to add my C Series Module to my LabVIEW Project. I have an EtherCATExpansion chassis NI-9144 or ...

I have my CompactRIO (cRIO) connected to my computer over the USB port, and it shows up under Devices and Interfaces in NI MAX. However, I am experiencing one of the following: No menu options appear ...

I know the sbRIO-9607 has an onboard RS-232 port. However, I would like to configure some of the sbRIO-9607 FPGA Digital Input/Output (Digital I/O) lines to work as RS232 or RS485/422 serial ports. Is ...

Due to limitations of Ethernet ports available on my host PC, I would like to use the USB A port on the sbRIO-9607 to deploy my LabVIEW program. Is this possible, and if so, how can this be done?