Filtered Results

I have an application working with an ethernet CompactDAQ (cDAQ), and I would like monitor programmatically the connection health between the cDAQ and the computer.

I have a CompactDAQ (cDAQ) chassis with a built-in controller running an NI Real-Time operating system. I am configuring my LabVIEW project and have added the cDAQ RT target in my Project Explorer, but ...

I want to measure the peak-to-peak voltage of a Waveform. I want to calculate the mean value (DC) of a Waveform.

How can I upgrade the version of the firmware of my C Series device? Does my C series module have a firmware version?

I'm using cDAQ platform and I am interested in acquire data from a third-party device that uses Profinet protocol.Does NI Offer Profinet C-series Module for cDAQ Platform?

I have an Ethernet CompactDAQ (cDAQ) chassis with multiple c series modules. My cDAQ chassis is connected to the local network. When I restart my computer, my Ethernet cDAQ chassis can be identified but ...

I ordered a cDAQ/cRIO chassis. Does it include a power supply? What if I want to power the chassis with a separate power supply? I am currently ordering a cDAQ/cRIO chassis. What power supply accessory ...

I am using Python to control my DAQ device. I can create a task and connect to the device, but I want to configure the timing options. How can I set the sample rate and sampling mode for my task?

I am setting up a DAQ device with a simple code and want to check the Physical Channel of a module. I am receiving the following message. Error -201087 occurred at Property Node DAQmx Channel Possible ...

I need to know which pins on the 10-pin screw terminal map to the 25-pin D-Sub end of the SH25M-10F Cable for C Series modules.

My NI Device is not correctly recognized in Measurement & Automation Explorer (NI MAX). I see the following behavior: The module is shown with a red X icon in NI MAX The module Settings window shows the ...

I have a DAQ device (cDAQ, USB, or PXI(e)) and I would like to communicate with it using low level VISA SCPI commands. Is this possible and is there a manual with the SCPI commands? Also, do SMU cards ...

I ran out of available Analog Input ports on my data acquisition device. However, there are some Digital Input ports available, can I use them as Analog Input ports? How are they going to behave?

I would like to calculate the impedance of a resistor. Can I use a Multifunction DAQ device to calculate the value of an unknown or variable resistance?

I have a CompactDAQ (cDAQ). I want to control my 3 stepper motors. These will be simple, straight line moves. Can I use my cDAQ?

This document is part of the Getting Started with NI-DAQmx Series. A Pulse Width Modulation (PWM) Signal is a technique for generating digital pulses to control an analog circuit. A PWM signal consists ...

We are using the same hardware on different computers in our project. Every time we connect the device(s) or reinstall a PC, the NI Product Registration Wizard window shows up to register the product(s). ...

This document is a part of How-To Guide for Most Common Measurements centralized resource portal. RTD Overview A platinum resistance temperature detector (RTD) is a device with a typical resistance of ...

I'm trying to use a NI cDAQ-9189 device.NI MAX shows the device as all ok and I can run the self-test. However I am trying to use the CompactDAQ with LabVIEW but I am not sure on how to do so. Are there ...

Showing 81-100 of 490 results
5 of 25 pages