From 12:00 AM CDT Sunday, October 17 - 11:30 AM CDT Sunday, October 17, ni.com will be undergoing system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

Filtered Results

I'm trying to do analog reference triggering and am getting the following error: Error -200264 occurred at DAQmx Start Task.vi

What is the difference between the sample clock (scan clock) and the convert clock (channel clock) on my multifunction data acquisition board?

I have one or more channels on my DAQ device not connected to any signal or sensor or the device is disconnected from the computer. Why are all of thechannels reading the same value? Why are my channels/signals ...

I am using an analog trigger to start an input acquisition on my NI 60xxE, 62xx or 63xx (formerly E, M, or X Series) device module. I set my trigger level to a certain voltage and notice that there is ...

How do I troubleshoot offset, incorrect, or noisy readings in my DAQ system? My DAQ device is measuring incorrect values. How do I troubleshoot this issue?

The following devices support programmable power up states: 6509 651x (6512, 6513, 6514, 6515) 652x (6525, 6527, 6528), All M Series boards (62xx) All X Series boards (63xx) You can set power-up states ...

I am using a NI X-series DAQ hardware, why do I get high output in the DIO lines during the computer powering up state or after computer is shut down. Can this be changed?

I would like to control a PXI/SCXI Combination Chassis with a PXI M Series device. Which device can be used and what do I need to pay attention to?

I have an NI PCIe (PCI Express) card and I want to know how many bus lanes it uses. In my Development PC, I have a few PCIe slots: x1, x4, x8, x16. Some of them are taken. How can I check if my card is ...

I am programming multiple tasks or connecting multiple terminal routes in an NI-DAQmx device, however I am getting the following error: Error -89137: Specified route cannot be satisfied, because it requires ...

I would like to accurately measure voltages between 14 V and 18 V. Is it possible to use a normal data acquisition +/-10V module to do this?

I am looking for a DAQ board with a certain maximum range. I understand that many boards have a maximum analog input voltage range of ±10 V, but are there other maximum voltage ranges available?

I want to output a chirp signal through my DAQ device in LabVIEW. Is there a way I can easily create a Chirp Signal in LabVIEW? Are there any considerations that need to be taken into account?

I have old DAQ hardware or hardware that uses DAQmx that I am not sure is supported in my version of LabVIEW. How do I determine if my version of LabVIEW or DAQmx is compatible with my hardware and operating ...

You depend on measurements to make key decisions and discoveries. NI offers a wide range of data acquisition products, including the low-cost DAQ family for basic applications such as simple data logging, ...

I am using multifunction I/O DAQ device. When I measure sine wave whose frequency is 500 kHz and the peak is 1 V, I found that the measured value has lower peak though I could measure 1 V level signal ...

Showing 61-80 of 719 results
4 of 36 pages