Filtered Results

Specifies the amount of attenuation provided by the probe connected to the channel. Specify this attenuation as a ratio. Not supported Not supported in VIs that run in a web application 2A88 attr2A88.html ...

Specifies whether to synchronize recognition of transitions in the signal to the internal timebase of the device. This property does not affect the minimum pulse width recognized by the device, but setting ...

Specifies in Hertz the frequency of the counter timebase. Specifying the rate of a counter timebase allows you to take measurements in terms of time or frequency rather than in ticks of the timebase. If ...

Specifies the asserted level of the exported Handshake Event if HshkEvent.OutputBehavior is Interlocked. Not supported Not supported in VIs that run in a web application High 10192 High state. Low 10214 ...

Specifies the terminal to which to route the Handshake Event. Not supported Not supported in VIs that run in a web application 22BA attr22BA.html

Specifies the maximum number of simultaneous USB transfers used to stream data. Modify this value to affect performance under different combinations of operating system and device. Not supported Not supported ...

Specifies on which edge of a digital signal to expire the watchdog task. Not supported Not supported in VIs that run in a web application Rising 10280 Rising edge(s). Falling 10171 Falling edge(s). 21A5 ...

Indicates the number of devices in the task. Not supported Not supported in VIs that run in a web application 29BA attr29BA.html

Specifies the type of trigger to use to mark a reference point for the measurement. Not supported Not supported in VIs that run in a web application Analog Edge 10099 Trigger when an analog signal crosses ...

Specifies the terminal to which to route the Reference Trigger. Not supported Not supported in VIs that run in a web application 590 attr590.html

Specifies in seconds the time to wait after the device receives the Reference Trigger before switching from pretrigger to posttrigger samples. Not supported Not supported in VIs that run in a web application ...

Specifies the digital pattern that must be met for the Reference Trigger to occur. Not supported Not supported in VIs that run in a web application 2187 attr2187.html

C Series devices can be grouped into scanned devices, slow sample devices, and delta-sigma devices based on acquisition behavior. This list does not include all C Series devices. C Series Scanned Devices ...

A microphone is a transducer that converts acoustical waves into electrical signals. The most common instrumentation microphone, a condenser microphone, uses a capacitive sensing element. A condenser microphone ...

Internal Channel Name Description _aignd_vs_aignd A differential terminal with the positive and negative terminals both connected to the ground reference for analog input. _ao0_vs_aognd A differential ...

The following devices have multiple timing engines on some subsystems. NI 4302, 4303, 4304, 4305, 4339, 4340, 4463, 4464, 4480, and 4481 NI 6533 and 6534 cDAQ-9132, 9133, 9134, 9135, 9136, 9137, 9174, ...

Devices use either multiplexed or simultaneous sampling. Simultaneous sampling devices have an ADC for each analog channel and can sample from all channels at the same time, as shown in the following figure. ...

Quantization error is the inherent uncertainty in digitizing an analog value as a result of the finite resolution of the conversion process. Quantization error depends on the number of bits in the converter, ...

A timing engine is the circuitry a device uses to control an acquisition or generation. Controlling an acquisition or generation includes: Utilizing timing signals to control when the device acquires or ...

During device initialization, all terminals on the I/O connector and trigger buses are tristated. Tristated means the terminal is floating or at high impedance. For the terminal to be driven from the device, ...

Showing 61-80 of 2160 results
4 of 108 pages