Filtered Results

Writes new pulse high tick counts and low tick counts to each channel in a counter output task that contains one or more channels. LabVIEW NXG does not support FPGA devices Not supported in VIs that run ...

Writes one or more digital waveforms to a task that contains one or more digital output channels. LabVIEW NXG does not support FPGA devices Not supported in VIs that run in a web application DAQmx Write ...

Gets the resistor level for lines when they are in tristate logic. LabVIEW NXG does not support FPGA devices Not supported in VIs that run in a web application DAQmx Get Power Up States (Digital Pull Up ...

Reads one or more digital waveforms from a task that contains one or more digital input channels. LabVIEW NXG does not support FPGA devices Not supported in VIs that run in a web application DAQmx Read ...

Specifies the lower limit of the window. Specify this value in the units of the measurement. Not supported Not supported in VIs that run in a web application 1428 attr1428.html

Terminal Names Explanation OnboardClock An alias for the terminal within a device where the default source for a clock can be found. If your application does not set the source of a clock (or uses an empty ...

The syntax for terminal names is a unique identifier that refers to a physical terminal in your system. To guarantee the uniqueness of a terminal name across multiple devices, terminal names begin with ...

Indicates whether there is an overcurrent condition on the channel. Not supported Not supported in VIs that run in a web application 21D9 attr21D9.html

Writes a single 32-bit unsigned integer sample to a task that contains one or more digital output channels. Use an instance that writes 32-bit unsigned integers for devices with up to 32 lines per port. ...

Specifies whether the data is returned by DAQmx Read when set on a raw strain channel that is part of a rosette configuration. Not supported Not supported in VIs that run in a web application 2FFA attr2FFA.html ...

Specifies whether to synchronize recognition of transitions in the signal to the internal timebase of the device. This property does not affect the minimum pulse width recognized by the device, but setting ...

Specifies under what condition to transfer data from the onboard memory of the device to the buffer. Not supported Not supported in VIs that run in a web application Onboard Memory More than Half Full ...

Specifies the output type of the analog output physical channels when the watchdog task expires. Not supported Not supported in VIs that run in a web application Voltage 10322 Voltage output. Current 10134 ...

Internal Channel Name Description _aignd_vs_aignd A differential terminal with the positive and negative terminals both connected to the ground reference for analog input. _ao0_vs_aognd A differential ...

Thermocouples are the most commonly used temperature sensors. A thermocouple is created when two dissimilar metals touch and the contact point produces a small open-circuit voltage that corresponds to ...

Indicates the serial number of the sensor. Not supported Not supported in VIs that run in a web application 21DC attr21DC.html

Indicates the IDs of the templates in the bitstream in TEDS.BitStream. Not supported Not supported in VIs that run in a web application 228F attr228F.html

Indicates the version letter of the sensor. Not supported Not supported in VIs that run in a web application 21DE attr21DE.html

Indicates the version number of the sensor. Not supported Not supported in VIs that run in a web application 21DD attr21DD.html

Specifies a description for the scale. Not supported Not supported in VIs that run in a web application 1226 attr1226.html

Showing 61-80 of 2006 results
4 of 101 pages