Filtered Results

I am using Python to control my DAQ device. I can create a task and connect to the device, but I want to configure the timing options. How can I set the sample rate and sampling mode for my task?

I need to know which pins on the 10-pin screw terminal map to the 25-pin D-Sub end of the SH25M-10F Cable for C Series modules.

I am setting up a DAQ device with a simple code and want to check the Physical Channel of a module. I am receiving the following message. Error -201087 occurred at Property Node DAQmx Channel Possible ...

This document is a part of How-To Guide for Most Common Measurements centralized resource portal. RTD Overview A platinum resistance temperature detector (RTD) is a device with a typical resistance of ...

We are using the same hardware on different computers in our project. Every time we connect the device(s) or reinstall a PC, the NI Product Registration Wizard window shows up to register the product(s). ...

I can see some incorrect peaks of data when measuring from a volumeflow sensor with DAQmx.Constant signal and volume flow are displayed on the control side of our system. A look with an oscilloscope also ...

I have a CompactDAQ system with a C series digital I/O module. I also have a proximity sensor wired to the digital I/O module which gives out a pulse train. Can I measure frequency of this pulse train ...

I'm using cDAQ platform and I am interested in acquire data from a third-party device that uses Profinet protocol.Does NI Offer Profinet C-series Module for cDAQ Platform?

This document is part of the Getting Started with NI-DAQmx Series. A Pulse Width Modulation (PWM) Signal is a technique for generating digital pulses to control an analog circuit. A PWM signal consists ...

How can I upgrade the version of the firmware of my C Series device? Does my C series module have a firmware version?

Showing 31-40 of 1056 results
4 of 106 pages