You depend on measurements to make key decisions and discoveries. NI offers a wide range of data acquisition products, including the low-cost DAQ family for basic applications such as simple data logging, ...

This document is part of the Getting Started with NI-DAQmx Series. A Pulse Width Modulation (PWM) Signal is a technique for generating digital pulses to control an analog circuit. A PWM signal consists ...

I need to use hardware-timing on ports other than port 0 of my X series device. However, when I configure my task to include other ports, I receive Error -201062, pictured below. When trying to use PFI ...

When I look at the user guides or specification documents of some NI data acquisition devices (DAQs), I see that 2 different sampling rates are available: single channel and multiple channels (aggregate). ...

Does my DAQ device support analog or digital triggering?

This tutorial provides step–by-step instructions for setting up your USB R Series device, adding it to a project, and creating an analog input acquisition using a DMA FIFO. Requirements Software LabVIEW ...

I want to control a stepper motor drive (step/direction) using the digital output on my USB DAQ and I have connected all the necessary wiring, so how do I control the motor for some simple moves in LabVIEW? ...

My DAQ device uses scatter-gather DMA to get data from the board to my computer, what does this mean?

I have seen products that were in a "Mature" state in their life cycle, but the product page of my hardware does not say anything about its life cycle. Can I safely assume it is in the Active stage of ...

I built a LabVIEWapplication and the behavior is not the same as in the development environment. The executable does not show any error, butit does not work correctly. I built an executable in LabVIEW ...