Filtered Results

Writes the specified binary value to the DAC on the specified physical channel at the specified range. Specify at least two calibration points for each physical channel and range you calibrate. Use 0 and ...

Writes a waveform that contains a single sample to a task that contains a single analog output channel. LabVIEW NXG does not support FPGA devices Not supported in VIs that run in a web application DAQmx ...

Returns the reference voltage or current values to be used by a reference device to create a reference signal. LabVIEW NXG does not support FPGA devices Not supported in VIs that run in a web application ...

Indicates the number of Analog Output synchronization pulse sources supported by the device. Not supported Not supported in VIs that run in a web application 692 attr692.html

Specifies a string that contains arbitrary, user-defined information. This number of characters in this string can be no more than Cal.UserDefinedInfo.MaxSize. Not supported Not supported in VIs that run ...

Specifies on which slope of the source signal the Reference Trigger occurs. Not supported Not supported in VIs that run in a web application Rising 10280 Trigger on the rising slope of the signal. Falling ...

You can use software timing or hardware timing to control when a signal is generated. With hardware timing, a digital signal, such as a clock on your device, controls the rate of generation. With software ...

NI-DAQmx supports multi-device routing. You simply specify the source terminal and destination terminal. If the two terminals are on different devices, NI-DAQmx uses the trigger bus to route the signal ...

Showing 31-40 of 2088 results
4 of 209 pages