Filtered Results

The specifications of my NI DAQ device show it has a built in CJC (cold junction compensation) sensor. How do I use this sensor with my temperature readings?

I am using National Instrument's .NET library for my application. I have a working application using the NI VISA/488.2 driver, now I bought a new data acquisition card that uses the NI DAQmx driver. I've ...

Is my C series module supported by the cDAQ chassis? I can not add this module to the cDAQ chassis in ni.com Advisor.

I am performing an Analog Output Task and getting the following error message: Error -200294 occurred at DAQmx Start.vi Possible reason(s): Not enough samples were written to satisfy the initial data ...

I need to synchronize two counter tasks on the same National Instruments DAQ device, how do I do this in NI-DAQmx and LabVIEW?

Sometimes my USB data acquisition device stops responding. Why is this happening? What is the best way to re-establish communication, and how can I prevent this behavior in the future? I receive error: ...

In the Datasheet for my product, I see a section titled Input Coupling, and it is specifies AC, DC, or "AC or DC."What are do each of these input coupling types mean? Does my module support DC voltage? ...

I would like to test my M Series device in NI-DAQmx to verify that the analog outputs and analog inputs are working. Are there any special channels I should use for diagnostics?

I'm reading a perfect sine wave in my Analog Input channel, and not the signal I'm supposed to have. Why are some devices showing yellows icons in NI Measurement and Automation Explorer (MAX)? My device ...

Showing 31-40 of 326 results
4 of 33 pages