I am trying to communicate with my third party instrument. VISA Test Panels are working in NI MAX, but I get the following error when I use the VISA example VIs. -1073807246: The resource is valid, but ...

I use NI-TimeSync to have my CompactRIOs support IEEE 1588-2008 Precision Time Protocol synchronization. However,my ARM-based NI Linux Real-Time (Linux RT) device always acts as a PTP slave, even if there ...

I want to communicate with my Real-Time target with LabVIEW NXG: I have a Real-Time device running an application developed in LabVIEW, but I would like to use LabVIEW NXG to develop a user interface to ...

I want to use a Network Stream to transfer data from my Real-Time controller to a VI running on my host computer. When I run the VI, I get error -314000: LabVIEW cannot load the ni_nwstreams library. ...

I am attempting to set up my CompactRIO, sbRIO, or PXI controller as a Real-Time target. I can see my device in the NI Measurement & Automation Explorer (MAX) under Remote Devices. When I attempt to Add/Remove ...

When I click on the drop down menu of the VISA Resource constant in my LabVIEW application, why am I not able to see the VISA resources of my CompactRIO (cRIO) system?

I have a Real-Time (RT) Controller in a PXI chassis that contains DAQ cards. When I open up NI MAX and click on any of my NI-DAQmx Global Virtual Channels I receive Error -88716. I started receiving this ...

In the scan mode (non FGPA) of the compactRIO, the sampling rate is normally limited at 1 kHz or less. I am trying to use LabVIEW to program the compactRIO, how do I change the sampling rate?

I would like to measure the frequency and the duty-cycle of a PWM-Signal (Pulse Width Modulated Signal) using a single physical channel and a single counter. Readingthe high time and low time measurements ...

I'm trying to deploy systems for the CompactRIO with DAQmx (cRIO-904x and cRIO-905x), but the Replication and Deployment (RAD) utility does not set the Module Programming Modes for the new chassis and ...