Filtered Results

I have multiple NI data acquisition (DAQ) devices. When I acquire data (DAQmx Read (VI) multiple channels) and then merge them in to one TDMS file by usingTDMS Write Function, the resulting file volume ...

How do I measure current with an analog voltage input? Do I need a shunt resistor in my current measurement circuit?

I want to control a stepper motor drive (step/direction) using the digital output on my USB DAQ and I have connected all the necessary wiring, so how do I control the motor for some simple moves in LabVIEW? ...

I am using some Digital Input (DI) lines on aNI-USB 621x device. How should the ground pins be connected? Can I connect a Digital Ground (D GND) pinon a NI USB-621x to an external ground reference? What ...

This article describes how to use a PXIe-634x card to define all PXI(e) backplane trigger lines simultaneously within LAbVIEW™. For demonstration purposes, the code in this article will refer to a PXIe-6341 ...

I want more precision on my DAQ device. Can I use a smaller voltage range to get more precision with my analog input?

I want to output a chirp signal through my DAQ device in LabVIEW. Is there a way I can easily create a Chirp Signal in LabVIEW? Are there any considerations that need to be taken into account?

The following devices support programmable power up states: 6509 651x (6512, 6513, 6514, 6515) 652x (6525, 6527, 6528), All M Series boards (62xx) All X Series boards (63xx) You can set power-up states ...

I am using an analog trigger to start an input acquisition on my NI 60xxE, 62xx or 63xx (formerly E, M, or X Series) device module. I set my trigger level to a certain voltage and notice that there is ...

I have one or more channels on my DAQ device not connected to any signal or sensor or the device is disconnected from the computer. Why are all of thechannels reading the same value? Why are my channels/signals ...

Showing 21-30 of 202 results
3 of 21 pages