Filtered Results

Gets the power up states for analog physical channels. LabVIEW NXG does not support FPGA devices Not supported in VIs that run in a web application DAQmx Get Power Up States (Analog).vi :/lvdaqmx.chm::/DAQmx ...

Creates a timing source that uses the signal you specify to determine when to send ticks to a Timed Loop. You must create a task that can generate the signal and wire that task to the task/channels in ...

Creates and configures a task that controls the watchdog timer of a device. The timer activates when you start the task. Use the digital physical channel expiration states input to set expiration states ...

Indicates the position in the buffer of the next sample to generate. This value is identical for all channels in the task. Not supported Not supported in VIs that run in a web application 1458 attr1458.html ...

Indicates the total number of samples acquired by each channel. NI-DAQmx returns a single value because this value is the same for all channels. For retriggered acquisitions, this value is the cumulative ...

Specifies the coupling for the source signal of the trigger if the source is a terminal rather than a virtual channel. Not supported Not supported in VIs that run in a web application AC 10045 Alternating ...

Internal Channels for the NI 9210 Device Internal Channel Name Description _aignd_vs_aignd A referenced single-ended terminal with the positive and negative terminals both connected to the ground reference ...

Not all E Series, M Series, S Series, and C Series devices support analog triggering. Refer to the specifications for your device to determine if your device supports analog triggering. Many C Series, ...

The following table lists the internal channel for the USB-9211 device. Internal Channel Name Description _cjtemp A differential terminal with the positive terminal connected to the onboard temperature ...

On an X Series device, you can either acquire a signal present on the I/O connector, or you can acquire a signal that is being generated from the internal calibration multiplexer. The channels available ...

An accelerometer, a sensor that represents acceleration as a voltage, comes in two axial types. The most common accelerometer measures acceleration along only a single axis. This type is often used to ...

There are three types of bridge configurations: quarter-bridge, half-bridge, and full-bridge. The number of active element legs in the Wheatstone bridge determines the kind of bridge configuration. Configuration ...

The following table lists common platinum RTD types and standards. All of these RTD types are supported in NI-DAQmx. Notice that there are some shared standards. The TCR and the Callendar-Van Dusen coefficients ...

The resolution and device range of a measurement device determine the smallest detectable change, called the code width, in the input signal. The smaller your code width, the more accurate your measurements ...

The type of input signal source (grounded or floating) and the configuration of the measurement system (differential, single-ended, pseudodifferential) determine how you connect signals to measurement ...

Devices use either multiplexed or simultaneous sampling. Simultaneous sampling devices have an ADC for each analog channel and can sample from all channels at the same time, as shown in the following figure. ...

Use the following guidelines to name your channels, tasks, and scales: Use any alphanumeric characters. Do not use nonalphanumeric characters with the following exceptions: In NI-DAQmx 7.4 or later, dashes ...

Raw data is in the native format and organization of the device, read directly from the device or buffer without scaling or reordering. The native format of a device can be an 8-, 16-, or 32-bit integer, ...

Generating the same data more than once is called regeneration. You can configure NI-DAQmx to allow or disallow regeneration by setting the Regeneration Mode attribute/property. By default, NI-DAQmx allows ...

Requirement I/O needs to be hardware-timed. All output values need to simultaneously update at the arrival of the sample clock edge. The application uses the Timed Loop. Solution Use the DAQmx Create Timing ...

Showing 21-40 of 2179 results
2 of 109 pages