Filtered Results

How to use the "Start trigger" function with NI-SCOPE just like in DAQmx? I tried to use "niScope Configure Trigger (poly)" but it did not work as I expected. I want to do a continuous measurement with ...

Typically, a high-speed digitizer uses an internal sample clock to determine the rate to acquire data. Are there occasions when it would be better to use an external clock source?

What is an eye diagram? What is it used for? What information is reflected in the waveform? What is the corresponding solution for NI?

My NI-Scope code is running in a simple loop where there are no configuration VIs between my niScope Initiate VI and my niScope Read VI. But when executing the code, I get: Error -1074118647 occurred ...

I am using NI-SCOPEmulti device session in my LabVIEW codeto configure a channel of each of the two NI PXIe-5162(4 Channel) in myPXI system. Iwould like to measure the Time Delay & Phase Delay between ...

Trigger timestamping and Waveform timestamping can be needed when you perform a measurement or synchronize a measurement. In this article, we will look at a NI-SCOPE-based implementation of Timestamp.

Averaging is a common operation in data acquisition, and you can perform this using the NI-Scope driver functions in LabVIEW.

How to use channel0 to trigger channel1 to acquire signal with PXI Oscilloscope like PXIe-5122. There is such feature in Soft Front Panel. How can I make it with LabVIEW program?

I need to know the exact time it is taking to my scope to acquire data in my application. The acquisition time of my Scope/Digitizer is not what I expect, and it is taking too much to acquire the data. ...

... PXI-5142 PXI-5152 PXI-5153 PXI-5154 PXI-5922 PCI-5105 ...

Showing 11-20 of 137 results
2 of 14 pages