Filtered Results

When I am using NI-DAQmx with support for LabVIEW, is the Raw Data from the DAQmx Read.vi calibrated? How can I convert the acquired binary values to scaled values?

The PXI(e) card in my chassis will not perform a Self-Calibration in NI MAX. I'm getting the following error message: Status Code: -201295 Device could not complete the calibration operation. Calibration ...

I want more precision on my DAQ device. Can I use a smaller voltage range to get more precision with my analog input?

I have a PCI(e) or PXI(e)66xx Counter/Timercard or a USB-6xxx Multifunction I/O with counter functionalityand I want to make sure the countersare working properly. How can I test mydeviceto see if it is ...

I am encountering error -200077 with a DAQmx VI: Error -200077 Requested value is not a supported value for this property. The property value may be invalid because it conflicts with another property. ...

I built a LabVIEWapplication and the behavior is not the same as in the development environment. The executable does not show any error, butit does not work correctly. I built an executable in LabVIEW ...

I have seen products that were in a "Mature" state in their life cycle, but the product page of my hardware does not say anything about its life cycle. Can I safely assume it is in the Active stage of ...

I am deploying an application that uses a USB DAQ device and everything works fine. However, every time I connect the USB DAQ device, the NI Device Monitor popup window shows up with a Device Detected ...

I want to know the error associated with the "Non-Linearity" of my DAQ device. What are the INL and DNL errors in the specifications of my DAQ device?

While reading the specifications of my DAQ device, I found a terminology called Absolute Accuracy at Full Scale. What is the meaning of Absolute Accuracy at Full Scale and how can I calculate it?

Showing 111-120 of 721 results
12 of 73 pages