Filtered Results

I would like to accurately measure voltages between 14 V and 18 V. Is it possible to use a normal data acquisition +/-10V module to do this?

When I set my trigger to be retriggerable and I run my VI I get the following error: Error -200077 occurred at Property Node DAQmx Trigger (arg 1) in DAQmx Start Trigger (Analog Edge).vi:2->Your VI Name.vi ...

I am using the Pulse Measurement Counter Input tasks in DAQmx with my DAQ device and I am getting the following error at DAQmx Create Channel VI: Error -200431 occurred at DAQmx Create Channel (CI-Pulse ...

I have old DAQ hardware or hardware that uses DAQmx that I am not sure is supported in my version of LabVIEW. How do I determine if my version of LabVIEW or DAQmx is compatible with my hardware and operating ...

I need to use hardware-timing on ports other than port 0 of my X series device. However, when I configure my task to include other ports, I receive Error -201062, pictured below. When trying to use PFI ...

I am programming multiple tasks or connecting multiple terminal routes in an NI-DAQmx device, however I am getting the following error: Error -89137: Specified route cannot be satisfied, because it requires ...

I want more precision on my DAQ device. Can I use a smaller voltage range to get more precision with my analog input?

I have a PCI(e) or PXI(e)66xx Counter/Timercard or a USB-6xxx Multifunction I/O with counter functionalityand I want to make sure the countersare working properly. How can I test mydeviceto see if it is ...

I built a LabVIEWapplication and the behavior is not the same as in the development environment. The executable does not show any error, butit does not work correctly. I built an executable in LabVIEW ...

Showing 101-110 of 342 results
11 of 35 pages