In addition to the required items, you may choose to provide one or more of the following ATCA I/O modules.

In addition to the kit contents, you must provide the following additional items: Single-Module ATCA Chassis [1] Note If your kit does not include a chassis, you can purchase one from ni.com or by contacting ...

This document describes how to install, configure, and test the ATCA-3671 FPGA Module for ATCA. The ATCA-3671 is programmable both through LabVIEW using LabVIEW FPGA and through BEEcube Platform Studio ...

Complete the following steps to connect a power supply to the ATCA-3671.

Ensure that the environment you are using the ATCA-3671 in meets the following specifications.

You can program the ATCA-3671 FPGA with LabVIEW FPGA.

Disconnect all cables from the ATCA-3671 module. Loosen the four captive screws on the front panel of the ATCA-3671 module. Push up on the latch and rotate the ejector handle away from the module to unseat ...

Complete the following steps to remove an ATCA I/O module from the ATCA-3671.

Disconnect all cables from the RTM. Loosen the four captive screws on the back panel of the RTM. Use the ejector handles to unseat the RTM from the chassis. Carefully remove the RTM from the chassis. Use ...

Figure 14. RTM-3661 Front Panel D D C C B B A A PCIe D PCIe D PCIe C PCIe C PCIe B PCIe B PCIe A PCIe A RTM-3661 Rear Transition Module for ATCA Designed by BEEcube Designed by