Filtered Results

I have a NI Multifunction I/O module with some Analog Output (AO) lines. I need to control an instrument using current. What is the current range the AO lines on my card?

I have a data acquisition device that I would like to use on my Linux machine.Where can I find a list of DAQ hardware modules and devices supported by or compatible with NI-DAQmx Base?

When I am using NI-DAQmx with support for LabVIEW, is the Raw Data from the DAQmx Read.vi calibrated? How can I convert the acquired binary values to scaled values?

The PXI(e) card in my chassis will not perform a Self-Calibration in NI MAX. I'm getting the following error message: Status Code: -201295 Device could not complete the calibration operation. Calibration ...

I want more precision on my DAQ device. Can I use a smaller voltage range to get more precision with my analog input?

I have a PCI(e) or PXI(e)66xx Counter/Timercard or a USB-6xxx Multifunction I/O with counter functionalityand I want to make sure the countersare working properly. How can I test mydeviceto see if it is ...

I am encountering error -200077 with a DAQmx VI: Error -200077 Requested value is not a supported value for this property. The property value may be invalid because it conflicts with another property. ...

I built a LabVIEWapplication and the behavior is not the same as in the development environment. The executable does not show any error, butit does not work correctly. I built an executable in LabVIEW ...

I have seen products that were in a "Mature" state in their life cycle, but the product page of my hardware does not say anything about its life cycle. Can I safely assume it is in the Active stage of ...

I am deploying an application that uses a USB DAQ device and everything works fine. However, every time I connect the USB DAQ device, the NI Device Monitor popup window shows up with a Device Detected ...

Showing 91-100 of 1145 results
10 of 115 pages