Filtered Results

I am deploying an application that uses a USB DAQ device and everything works fine. However, every time I connect the USB DAQ device, the NI Device Monitor popup window shows up with a Device Detected ...

When I am using NI-DAQmx with support for LabVIEW, is the Raw Data from the DAQmx Read.vi calibrated? How can I convert the acquired binary values to scaled values?

Why do I receive Error -200558 whenI try to use a task that contains multiple DAQ devices? One task cannot contain multiple independent devices. Create one task for each independent device.

I have two I/O devices of the same type (i.e. two sinking or two sourcing ones). I want to connect them together. Is that possible? Does my sinking output device require an external voltage source?

I know that bias resistors should be used when measuring floating sources with differential input or nonreferenced single-ended (NRSE) input systems. However, I am not sure what resistance values I should ...

What is the difference between the sample clock (scan clock) and the convert clock (channel clock) on my multifunction data acquisition board?

I am using a NI X-series DAQ hardware, why do I get high output in the DIO lines during the computer powering up state or after computer is shut down. Can this be changed?

I am using an analog trigger to start an input acquisition on my NI 60xxE, 62xx or 63xx (formerly E, M, or X Series) device module. I set my trigger level to a certain voltage and notice that there is ...

I have one or more channels on my DAQ device not connected to any signal or sensor or the device is disconnected from the computer. Why are all of thechannels reading the same value? Why are my channels/signals ...

Showing 91-100 of 343 results
10 of 35 pages