Filtered Results

I have a device with a Delta-Sigma ADC like a NI DSA, C Series or SC Express device and I have noticed the following scenarios. When I set a constant sampling rate on my NI Dynamic Signal Acquisition (DSA) ...

I want to synchronize my Counter Input (CI) task of NI 9361 with my Analog Input (AI) task of a DSA (Dynamic Signal Acquisition) module, such as NI 9234. How can I achieve this synchronization?

I am purchasing a C Series module and the purchase page is requiring that I purchase an EMI Suppression Ferrite. Why is that? Is the EMI Suppression Ferrite really required to use my C Series module or ...

I have a CompactDAQ (cDAQ) chassis with a built-in controller running an NI Real-Time operating system. I am configuring my LabVIEW project and have added the cDAQ RT target in my Project Explorer, but ...

I have one or more channels on my DAQ device not connected to any signal or sensor or the device is disconnected from the computer. Why are all of thechannels reading the same value? Why are my channels/signals ...

I would like to calculate the impedance of a resistor. Can I use a Multifunction DAQ device to calculate the value of an unknown or variable resistance?

We are using the same hardware on different computers in our project. Every time we connect the device(s) or reinstall a PC, the NI Product Registration Wizard window shows up to register the product(s). ...

I use an NI 9151 R Series expansion chassis with a PXI R Series module. Will using an expansion chassis affect the performance of C Series modules compared to using it with other CompactRIO chassis? Is ...

I am using a C Series module with a Delta-Sigma ADC like a NI 9234 to acquire analog signals using the FPGA in my CompactRIO. When I try to perform the acquisition, I get the following error. Error 65582 ...

I have two or more C Series modules that have a delta-sigma ADC, each in their own cDAQ chassis. How can I synchronize these modules?

I have some dynamic signal acquisition (DSA) modules in my CompactRIO and I would like to synchronize them in LabVIEW FPGA. How should I go about doing this? I am using a cRIO with two dynamic signal acquisition ...

Showing 1-12 of 12 results