Filtered Results

What is an eye diagram? What is it used for? What information is reflected in the waveform? What is the corresponding solution for NI?

How to use the "Start trigger" function with NI-SCOPE just like in DAQmx? I tried to use "niScope Configure Trigger (poly)" but it did not work as I expected. I want to do a continuous measurement with ...

My NI-Scope code is running in a simple loop where there are no configuration VIs between my niScope Initiate VI and my niScope Read VI. But when executing the code, I get: Error -1074118647 occurred ...

I have a National Instruments PXI Oscilloscope card and my device fails the self-test in NI Measurement & Automation Explorer (MAX) with one of the error codes below: -239000 -239001 -239020 -239022 -200550 ...

I am using NI-SCOPEmulti device session in my LabVIEW codeto configure a channel of each of the two NI PXIe-5162(4 Channel) in myPXI system. Iwould like to measure the Time Delay & Phase Delay between ...

I am attempting to put together a system to do Time Domain Reflectometry (TDR), which observes the reflected waveforms in transmission lines. This could involve data acquisition, digital signal processing ...

I have an NI-SCOPE device and would like to adjust the Channel 0 vertical range independently of the Channel 1 vertical range. I have tried using the niScope Configure Vertical VI but it changes the settings ...

I need to know the exact time it is taking to my scope to acquire data in my application. The acquisition time of my Scope/Digitizer is not what I expect, and it is taking too much to acquire the data. ...

Typically, a high-speed digitizer uses an internal sample clock to determine the rate to acquire data. Are there occasions when it would be better to use an external clock source?

Showing 1-12 of 12 results