Filtered Results

A DAQmx property node preselected to contain Timing class properties. You can select other classes from the node on the diagram.

A DAQmx property node preselected to contain Device class properties. You can select other classes from the node on the diagram.

Use the DAQmx Physical Channel properties to query information about physical channels. Use the DAQmx Channel properties to configure virtual channels.

A terminal is a named location where a signal is either generated (output or produced) or acquired (input or consumed). A terminal that can output only one signal is often named after that signal. A terminal ...

A DAQmx property node preselected to contain System class properties. You can select other classes from the node on the diagram.

Specifies in seconds the minimum pulse width the filter recognizes as a valid high or low state transition. Not supported Not supported in VIs that run in a web application 21D7 attr21D7.html

Specifies in hertz the rate of the digital filter timebase. NI-DAQmx uses this value to compute settings for the filter. Not supported Not supported in VIs that run in a web application 2ED5 attr2ED5.html ...

Specifies the terminal of the signal to use as the timebase of the digital filter. Not supported Not supported in VIs that run in a web application 2ED4 attr2ED4.html

Specifies whether to synchronize recognition of transitions in the signal to the internal timebase of the device. Not supported Not supported in VIs that run in a web application 2ED6 attr2ED6.html

Specifies whether to invert the lines in the channel. If you set this property to TRUE, the lines are at high logic when off and at low logic when on. Not supported Not supported in VIs that run in a web ...

Specifies the logic family to use for acquisition. A logic family corresponds to voltage thresholds that are compatible with a group of voltage standards. Refer to the device documentation for information ...

Specifies for NI-DAQmx to map hardware registers to the memory space of the application, if possible. Normally, NI-DAQmx maps hardware registers to memory accessible only to the kernel. Mapping the registers ...

Indicates the number of Booleans per channel that NI-DAQmx returns in a sample for line-based reads. If a channel has fewer lines than this number, the extra Booleans are FALSE. Not supported Not supported ...

Indicates the number of digital lines in the channel. Not supported Not supported in VIs that run in a web application 2178 attr2178.html

Specifies whether to tristate the lines in the channel. If you set this property to TRUE, NI-DAQmx tristates the lines in the channel. If you set this property to FALSE, NI-DAQmx does not modify the configuration ...

Specifies the maximum number of simultaneous USB transfers used to stream data. Modify this value to affect performance under different combinations of operating system and device. Not supported Not supported ...

Specifies the maximum size of a USB transfer request in bytes. Modify this value to affect performance under different combinations of operating system and device. Not supported Not supported in VIs that ...

Specifies the terminal to which to route the Divided Sample Clock Timebase. Not supported Not supported in VIs that run in a web application 21A1 attr21A1.html

Specifies the data transfer mode for the device. Not supported Not supported in VIs that run in a web application DMA 10054 Direct Memory Access. Data transfers take place independently from the application. ...

Showing 1-20 of 1958 results
1 of 98 pages