Filtered Results

Add a While Loop to continuously generate the signal and check the generation status until you click the Stop button.

The following figures show the two possible slot configurations for the NI 5672 module in an 8-slot NI PXIe-1062Q hybrid chassis. Figure 3. NI 5672 Module in Slots 2, 3, and 4 of an NI PXIe-1062Q Chassis ...

Use Measurement & Automation Explorer (MAX) to configure your NI hardware. MAX informs other programs about which NI hardware products are in the system and how they are configured. MAX is automatically ...

The NI 5672 is a precision RF instrument that is sensitive to ESD and transients. Ensure you take the following precautions when making direct connections to the NI 5672 to avoid damaging the device.

This product was tested and complies with the regulatory requirements and limits for electromagnetic compatibility (EMC) stated in the product specifications. These requirements and limits are designed ...

The LEDs may not illuminate until the device has been configured in MAX. Before proceeding, verify that the NI 5672 appears in MAX. If the ACCESS LED fails to illuminate after you power on the chassis, ...

In the MAX configuration tree, click Devices and Interfaces . Expand the Chassis tree to see the list of installed devices, and press to refresh the list. If the module is still not listed, power ...

Caution To prevent damage to the device caused by ESD or contamination, handle the device using the edges or the metal bracket. Ensure the AC power source is connected to the chassis before installing ...

You must be an Administrator to install NI software on your computer. Install an ADE, such as LabVIEW or LabWindows™/CVI™. Insert the driver software DVD into your computer. The installer should open automatically. ...

Figure 5. NI 5672 Front Panel Interconnection 2 1 Flexible SMA-to-SMB Cable Flexible SMA-to-SMB Cable Using a flexible SMA-to-SMB cable, connect the INPUT connector on the NI 5610 front panel to the CH ...

Restart the system. Launch MAX, and perform the self-test again. Power off the chassis. Reinstall the failed module in a different slot. Power on the chassis. Perform the self-test again.

Note Before you begin, install and configure your chassis and controller. This document explains how to install, configure, and test the NI PXIe-5672 ( NI 5672 ). The NI 5672 is a 2.7 GHz RF vector signal ...

There are several required items not included in your device kit that you need to install or operate the NI 5672.

You can generate signals interactively using the NI-RFSG Soft Front Panel (SFP) or you can use the NI-RFSG instrument driver to program your device in the supported ADE of your choice.

Showing 1-20 of 84 results
1 of 5 pages