Filtered Results

I am using the Pulse Measurement Counter Input tasks in DAQmx with my DAQ device and I am getting the following error at DAQmx Create Channel VI: Error -200431 occurred at DAQmx Create Channel (CI-Pulse ...

My DAQ device uses scatter-gather DMA to get data from the board to my computer, what does this mean?

When I am using NI-DAQmx with support for LabVIEW, is the Raw Data from the DAQmx Read.vi calibrated? How can I convert the acquired binary values to scaled values?

I have a 2-wire, 3-wire, or 4-wire Resistance Temperature Detector (RTD) that I want to connect to my data acquisition (DAQ) device. What do the different color wires on my RTD mean, and how do I physically ...

This article provides guidance on how often NI devices need to be calibrated and how to find the specific calibration interval for individual Multifunction I/O DAQ, Digital Instruments, High-Speed Digital ...

In the DAQ device specification sheet, there is about a type of ADC(Analog-to-Digital Converters). What types of ADC are used in National Instruments DAQ Devices, such as Multifunction I/O DAQ, DSA or ...

I have seen products that were in a "Mature" state in their life cycle, but the product page of my hardware does not say anything about its life cycle. Can I safely assume it is in the Active stage of ...

This document is part of the Getting Started with NI-DAQmx Series. A Pulse Width Modulation (PWM) Signal is a technique for generating digital pulses to control an analog circuit. A PWM signal consists ...

I am using an analog trigger to start an input acquisition on my NI 60xxE, 62xx or 63xx (formerly E, M, or X Series) device module. I set my trigger level to a certain voltage and notice that there is ...

Showing 1-10 of 58 results
1 of 6 pages