Filtered Results

Applies offset, in seconds, to the sample clock relative to the reference clock when using the onboard clock. Each time this node is called, the sample clock is offset from the reference clock by the specified ...

Extracts a session that can be passed to NI-TClk nodes. Not supported Not supported in VIs that run in a web application session in Handle that identifies the NI-SCOPE instrument session as previously ...

Performs initialization actions with extra options. This node performs the following initialization actions: Creates a new IVI instrument driver session and, optionally, sets the initial state of the following ...

For background on manual adjustment, refer to Manual Adjustment of NI-TClk Synchronization. Before beginning this procedure, complete the following: Self-calibrate all instruments in your test system. ...

Performs a hard reset of the device. During a hard reset, acquisition stops, all routes are released, RTSI and PFI lines are tri-stated, FPGAs are reset, hardware is configured to its default state, and ...

Resets the oscillator to a known state and resets session attributes to values specified in the IVI configuration store. This function uses default parameters to perform a software reset on the device. ...

Resets the digitizer to its default state. Not supported Not supported in VIs that run in a web application session in Handle that identifies the NI-SCOPE instrument session as previously allocated by ...

Returns the revision numbers of the instrument driver and instrument firmware. Not supported Not supported in VIs that run in a web application session in Handle that identifies the NI-SCOPE instrument ...

Self-calibrates most NI digitizers, including all SMC-based devices. Not supported Not supported in VIs that run in a web application Self-Calibrating SMC-Based Devices For SMC-based devices, if the self-calibration ...

Showing 1-10 of 133 results
1 of 14 pages