Filtered Results

Creates a new session for the hardware, sets initial values of certain properties for the session, and sends initialization commands to reset all hardware modules to a known state necessary for NI-RFSA ...

Transfers acquired waveform data from device memory to computer memory; this process is also known as fetching. The data transferred is acquired to onboard memory previously by the hardware after the acquisition ...

Initializes an EEPROM-specific external alignment step. Not supported Not supported in VIs that run in a web application This node supports the following hardware: PXIe-5605 (PXIe-5665 only) PXIe-5606 ...

Commits settings to hardware, waits for hardware settling, and starts an acquisition. Not supported Not supported in VIs that run in a web application This node supports the following hardware: PXIe-5601/5603/5605/5606 ...

Returns an array to indicate which calibration steps contain valid calibration data. Not supported Not supported in VIs that run in a web application This node supports the following hardware: PXIe-5663E/5665/5667/5668 ...

Performs self-calibration on the NI-RFSA device and associated modules that support self-calibration. If the self-calibration is successful, the new calibration constants are stored immediately to the ...

Sends a trigger to the device when you use Configure Trigger to choose a software version of a trigger and the device is waiting for the trigger to be sent. You can also use this node to override a hardware ...

Creates a new configuration list step in the configuration list for RF list mode specified by the Active Configuration List property. When you create a configuration list step, a new instance of each property ...

Showing 1-10 of 103 results
1 of 11 pages