Filtered Results

I have a National Instrumentshardware configurationand I want to use one input signal to trigger a particular task or operation on my LabVIEW code. I want to synchronizetwo tasks to execute one after the ...

I need to use hardware-timing on ports other than port 0 of my X series device. However, when I configure my task to include other ports, I receive Error -201062, pictured below. When trying to use PFI ...

I would like to configure some of the DIO lines for input while other lines in the same DIO port are configured for output. On which boards can the DIO lines be individually configured? In software I am ...

I am performing a digital output task on the USB-6525, during which I receive Error -201278: The frequency of successive write operations is too high. The device cannot guarantee a reliable transmission. ...

I have seen products that were in a "Mature" state in their life cycle, but the product page of my hardware does not say anything about its life cycle. Can I safely assume it is in the Active stage of ...

I want to use the output of the USB-6525 as an input to a valve for my application, however, the valve needs an input of 24V as its input. Is the voltage produced by P0 (Port 0) or the output ports fixed? ...

Showing 1-6 of 6 results