Filtered Results

Is it possible to use the NI Digital Pattern Source or Capture Waveform functionality to generate or read data that spans more than 32 pins? If so, how?

I'm unable to burst my patterns whenever I try to configure them with Active Load enabled. I get the following error message: Error -1074097882 occurred at niDigital Burst Pattern (Burst Only).vi ...

In NI Digital Pattern Editor, I use Source opcode in my pattern to output predetermined frames to communicate with another device. I noticed that at high frequency, there are level errors in the generated ...

I do not see that the Active LED ofPXIe-6570 light when I poweron the controller.Is there any problem with it?

NI Digital Pattern Files are a type of file used with the NI-Digital Pattern Instruments, PXIe-657X series, that describe a pattern to burst. These label names are used by the NI-Digital "Configure Start ...

I am receiving an "Error Applying Pin Levels" popup window when trying to apply my levels in Digital Pattern Editor I am getting an error that states "source terminal to be routed could not be found on ...

I want to create a CLK of 100 MHz or higher using the PXIe-6570 Digital Pattern Instrument (DPI). The PXIe-6570 Specification states that the maximum vector rate is 100 MHz. Can I create a pattern for ...

I am attempting to put together a system to do Time Domain Reflectometry (TDR), which observes the reflected waveforms in transmission lines. This could involve data acquisition, digital signal processing ...

Showing 1-10 of 30 results
1 of 3 pages