Filtered Results

I have a device with a Delta-Sigma ADC like a NI DSA, C Series or SC Express device and I have noticed the following scenarios. When I set a constant sampling rate on my NI Dynamic Signal Acquisition (DSA) ...

Why do some IEPE and ICP sensors specify Excitation Voltage, and how does that relate to the Compliance Voltage specification for National Instruments’ IEPE products like the NI 4461, NI 4462, NI 4464, ...

How can I programmatically adjust the excitation voltage on my DAQ card? I have NI hardware that provides excitation voltage to a sensor. When I stop my program, the device retains the last excitation ...

I am trying to use thenew BNC version of NI 9230 or NI 9232 C Series module in my CompactDAQ (cDAQ) chassis. I can't see my module, and it is not recognized by Windows Device Manager or NI Measurement ...

The NI 92xxE, NI 94xxE, NI 95xxE, and NI 98xxE OEM single-board (sbRIO) modules appear as an unsupported module in Measurement & Automation Explorer (MAX) with my CompactDAQ (cDAQ) chassis or controller, ...

I am monitoring my DAQmx global virtual channels in NI Distributed System Manager. They are displaying as gray with the message "0 (Unknown Bad Quality)" or"(Unknown Bad Quality)". I see this issue with ...

I have a NI-9231 module in a cDAQ-9189 chassis. When I try to open NI MAX Test Panel for the NI-9231 module, I get the following error: Error -225202 occured at daqmxcfg_DAQmx Start Task .vi:4410001 ...

I use an NI 9151 R Series expansion chassis with a PXI R Series module. Will using an expansion chassis affect the performance of C Series modules compared to using it with other CompactRIO chassis? Is ...

How do I configure a load cell in NI Measurement & Automation Explorer (NI MAX)?

Showing 1-10 of 756 results
1 of 76 pages